Dealing with stained Marble Shower Tiles

The picture below really tells the story but basically this is bathroom from a house in Kidlington that has been tiled with Marble mosaic wall tiles which has become stained around the bath. Additionally the silicone strip between the bath and the wall had become badly stained with mould and needed replacing.

Tumbled marble mosaic bathroom Kidlington before

Refreshing Marble Wall Tiles

To get the tile and grout clean I decanted a strong dilution of Tile Doctor Pro Clean into a spray bottle and began to apply it in sections to the Marble mosaic wall tiles. Mixing the cleaning solution with air makes it lighter and less likely to run off the wall giving it chance to dwell on the tile and get to work. I left it to soak in for a few minutes before scrubbing into the tile and grout with a stiff brush finishing with a rinse with water; this process was then repeated on stubborn stains and the rest of the area until the wall was clean. Then the mouldy silicone was removed from around the bath, dried and replaced with new.

Sealing Marble Mosaic Tile

The wall was dried and then the mosaic tiles sealed with two coats of Tile Doctor Colour Grow which is an impregnating sealer that penetrates into the pores of the Marble to make an effective barrier. Colour Grow also enhances the colour of natural stone so when finished the colour of the tiles were far more vibrant which was especially noticeable around the bath trim where the tiles had gone white.

Tumbled marble mosaic bathroom Kidlington after

The client was extremely happy with the result and was considering completely replacing the tiles.
 
 
Source: Professional Tile, Stone and Grout maintenance service in Oxfordshire

Polishing Tumbled Marble

This 50m2 Tumbled Marble tiled floor in Dewlish, near Dorchester had not been deep cleaned and re-sealed for at least five years and showed signs of the normal wear and tear associated with a busy kitchen/dining room and a dog that enjoyed muddy walks. The old sealer was now breaking down allowing dirt to become ingrained in the Marble making it difficult to clean.

Tumbled Marble in Dewlish Before Cleaning

Stripping a Tumbled Marble Floor

To restore the surface finish it needed to be burnished using a set of diamond encrusted burnishing pads. The pads come in a number of different grades from coarse (used to strip off sealers and dirt from the Marble) too very fine (used for final polishing) and are applied one after another starting with the coarse pad and moving through to the very fine pad towards the end. Each stage requires a little water which captures the soil and is rinsed away and removed with a wet vacuum. This process completely removed the old sealer and surfaces scratches with a new shine. The floor was given a thorough wash down at this point again using a wet vacuum to remove as much water as possible from the surface before leaving it to dry for the evening.

Sealing Tumbled-Marble Tiles

The next day the Marble had dried and I started to seal the tiles using two coats of Tile Doctor Colour Grow sealer which was first applied to a couple of test tiles first to ensure it gave the effect the customer was looking for.

Tumbled Marble in Dewlish During Sealing

Colour Grow is a colour enhancing sealer that brings out the natural colour of the tile and certainly the customer was pleased with the results so the sealing work continues until the whole 50m2 floor had been sealed with two coats.

Tumbled Marble in Dewlish After Cleaning and Sealing

When the whole fifty square metres of floor had been sealed using Colour Grow the effect was dramatic and the owners were so pleased with the result that they invited over a friend with a similar stone floor who immediately asked for her floor to be done in the same way.
 
 
Source: Cleaning Tumbled Marble in Dorset