Marble Wall and Floor Tiled Wet Room Renovated in Sheffield

The owner of this house in the village of Endcliffe Sheffield was unhappy about the state of their Marble wet room and called me in to do something about it. The main issue was that mould had built-up across the bathroom especially on the grout and silicone sealant, the Marble tiles were also looking dull and needed sprucing up.

Marble Bathroom Tiles Before Cleaning Endcliffe Sheffield

Dealing with Mould in a Wet Room

Mould thrives in moist warm conditions and without adequate ventilation it will start to take hold. Often in cases like this we advise clients to improve the power of their extractor fan or leave a window and a door open after a shower, in this case however the wet room had no windows. Another option you can try is to run the shower cold for a few minutes after you have used it, this decreases the temperature and removes moisture from the air. That tip is easily forgotten when your in a hurry so regular cleaning with Tile Doctor Duo-Clean which is a tile cleaner and mould remover should allow you to keep on top of the problem.

Marble Bathroom Tiles Before Cleaning Endcliffe Sheffield Marble Bathroom Tiles Before Cleaning Endcliffe Sheffield

In this case the Mould had really taken a hold and I knew form experience that scrubbing with a powerful cleaner like Duo Clean was unlikely to get the grout back to the pristine condition the customer wanted so I decided to strip out all the affected grout and silicone and replace with new. It took some time but I have a special electric grout removal tool that comes in handy for these situations and so it wasn’t long before I had removed the worse of it. This was followed by carefully removing the silicone sealant that ran between the shower tray and Marble wall tiles with a sharp knife.

Polishing Marble Wall and Floor Tiles

Next, I turned my attention to the Marble tiles which had lost their shine and become dull. Marble is hard stone and to get the best out of it we find its best to burnish them with a set of diamond encrusted burnishing pads that remove the dirt and slowly bring back the polished appearance. Normally when we talk about burnishing it’s in relation to stone floor tiles however these pads also come in small six-inch size as well which will fit a hand buffer or Angle Grinder.

Marble Bathroom Tiles During Cleaning Endcliffe Sheffield

Like floor burnishing the pads are applied in sequence starting with the coarse 400-grit pad and moving up through the 800, 1500 and finally the very fine 3,000-grit pad. The lower grit pads need to be lubricated with water and you rinse between each pad with water to remove the slurry that is generated.

Finishing the Marble Wet Room Renovation

With the Marble tiles now looking good it was time to protect them from future staining by sealing them with two coats of Tile Doctor Ultra-Seal which is a premium sealer that leaves a natural look that doesn’t darken the colour of the stone.

I left the re-grouting to last as its easier to remove grout from a sealed tile and then finished by putting back the silicone strip, both the grout and the silicone we chosen for their anti-mould formula and before leaving I gave some advice on how to keep on top of the mould problem going forward.

Marble Bathroom Tiles After Cleaning Endcliffe Sheffield

My client was delighted with the result and relieved that they would no longer feel embarrassed when visitors ask to use the bathroom.

Marble Bathroom Tiles After Cleaning Endcliffe Sheffield

 
 
Source: Marble Tile Cleaning and Polishing Service in Sheffield

Beautiful Marble Tiled Floor Polished in Willington Cheshire

Although expensive Marble is a highly coveted, popular and classic flooring choice, not only is it hard wearing you can attain a high polish that simply looks fantastic. At peak condition, it’s one of the most beautiful and eye-catching types of stone available, however it’s appearance will degrade over time and with use, so it does need maintaining.

This customer, who lives in the small village of Willington in Cheshire had contacted us because they were concerned that the lustre on their Marble tiled floor which had been installed throughout much of the ground floor had faded and lost its attractive appearance. We arranged a date to go over and re-polish the floor back to health.

Marble Tiled Floor Before Cleaned and Polished Willington Cheshire

Burnishing and Cleaning a Marble Tiled Floor

On arrival the first step was to give the floor a general clean using a mild dilution of Tile Doctor Pro-Clean which is an alkaline tile cleaning product that is safe to use on Marble. I mention this because there are many cleaning products on the market today which are acidic and really only meant for use on Vinyl and Ceramic tiles. The cleaning solution was applied by sponge mop and left to soak for ten to twenty minutes with a particular focus on the grout lines. I used a stiff brush along the grout lines to get them really clean and then once done the floor was then rinsed with clean water and the now soiled cleaning solution removed with a wet vacuum. This process also has the added advantage of removing any grit from the floor which might cause scratching during the next stage which was to polish the floor.

The next step was to use a set of Tile Doctor burnishing pads to polish the stone back to a deep shine. The pads which are encrusted with industrial diamonds are applied with a rotary floor buffer in sequence from coarse to extra fine. The first pad has a Coarse 400 grit which is applied with only water for lubrication, removes minor scratches, sealers, and the top surface dirt. Working in small areas, I applied the pad across the Marble, rinsing in between and picking up the soiled solution with a wet-vac machine. I then repeated this same procedure with the Medium 800 grit pad which is the first stage polishing pad again rinsing with water after use. The next two pads are a Fine 1500 grit and Extra Fine 3,00 grit which really build up a high-quality polish on the stone.

Sealing a Marble Tiled Floor

The floor was left to dry off fully overnight and I returned the next day to seal the Marble first checking with a damp meter that the stone was dry. To seal the Marble tiles I applied two coasts of Tile Doctor Colour Grow which is an impregnating sealer that works by occupying the pores in the stone thus preventing dirt from becoming ingrained. Colour Grow also has the added advantage of enchasing the natural colours in the stone and in this case brought out the deep brown colours in the Marble.
Once the sealer had dried the floor was treated to a gentle buff with a white pad to bring up the shine even further.

Marble Tiled Floor After Cleaned and Polished Willington Cheshire Marble Tiled Floor After Cleaned and Polished Willington Cheshire

 
 
Source: Marble Tile Cleaning and Polishing Service in Willington, Cheshire

Restoring Ruined Marble Wall Tiles in a Surrey Shower

Marble tiles are a fantastic choice of stone for a shower cubicle because of its distinctive characteristics and quality. It can really add a luxurious feel and when used in a bathroom take it to the next level.

However, it’s extremely important to note that Marble like all natural stone is a porous and acid-sensitive material. It must therefore be cleaned with care using suitable products. This particular Marble tiled shower cubicle at a property in Leatherhead is a good example of this done wrong. The owner had used an acid-based cleaning product to clean the stone, resulting in damage to the sealer and causing unappealing streaks to form.

Marble Shower Wall Leatherhead Before Cleaning

This type of damage can appear irreparable but, with the right combination of cleaning methods and products, it can be fixed. Once the old sealer has been removed, and the tiles have been cleaned, polished and re-sealed, they can look as a good as new. Here’s how I helped this customer restore the Marble shower cubicle.

Cleaning and Polishing a Marble Shower Cubicle

To begin the restoration, I scrubbed the dirty grout lines using Tile Doctor Pro-Clean, which is a highly reliable and multi-purpose alkaline-based product. I then rinsed the tiles with water to remove the traces of cleaning product.

Next, I moved on to the polishing stage of the restoration – what we often refer to as burnishing. This involved the use of small six-inch diamond-encrusted burnishing pads applied with a hand buffer and with different levels of grit – ranging from Coarse to Very Fine. I started with the Coarse grit pad and worked my way sequentially through our four-pad system, polishing the stone with Medium, Fine and eventually the Very Fine pad to really bring up the polish.

Sealing a Marble Shower Cubicle

Once the shine had returned to the Marble and the damage had been removed, I re-sealed the tiles using two coats of Tile Doctor Colour Grow, a penetrating sealer designed to enhance the natural colours and patina of the stone. Once dry, I gave the tiles a final polish with a white buffing pad to put the finishing touches on the restoration.

Marble Shower Wall Leatherhead After Cleaning

The customer was thrilled with the results, saying:
“I’m really happy with the result and we will make sure we don’t use supermarket cleaners again on natural stone. Rupert was a very personable tradesman who took pride in what he was doing. He has identified Tile Doctor Neutral Tile Cleaner as being the product we should have used in the first place and has sent me the website details.”
Another satisfied customer!
 
 
Source: Marble Tile Cleaning and Restoration Service in Surrey